Installation Instructions / Warranty Axor Carlton 17010XX1
Axor Carlton Single Control Lavatory Faucet 17010XX1 Technical Specification Hole size in mounting surface Minimum 1-3/8” Maximum 1-5/8” Maximum mounting surface depth 1-1/4” Flow rate 2.2 GPM Maximum operating pressure 145 PSI Recommended operating pressure 22 - 72.5 PSI Recommended hot water temp 120o - 140o F* M3 cartridge with BolticTM handle screw *Some governing bodies require that the water heater be set to 120o F or less.
Install the faucet Place the faucet and sealing ring on top of the mounting surface. Install the mounting flange over the stud. Thread the collar onto the stud until the mounting flange is firmly against the bottom of the mounting surface. stud sealing ring mounting flange collar Secure the supply lines to the stop valves with the 3/8” compression fittings (not included). Use two wrenches to insure that supply hoses do not twist.
Install the pop-up drain Remove the plunger assembly. Unscrew the drain outlet flange from the tee. plunger Unscrew the tailpiece from the tee. Wrap the threads with two layers of Teflon tape and replace. height adjuster flange Install the white, flexible sealing gasket to the flange. Place it in the sink outlet. From under the sink, install the black mack gasket, white friction ring and retainer nut to the flange. Do not tighten the nut against the bottom of the sink at this time.
Re-set the High Temperature Limit Stop (optional) Close the drain OR cover it with a wash cloth. Use a 4 mm Allen wrench to push the screw cover into the handle. Retrieve the screw cover when the handle is removed. Use the 4mm Allen wrench to loosen the handle screw 4 complete revolutions. Remove the handle and put it in a safe place. Remove the decorative nut cover and put it in a safe place. Remove the handle screw from the stem of the cartridge. Remove the high temperature limit stop.
User Instructions • Push the handle up to turn the water on. • Pivot the handle to the left for hotter water, to the right for cooler water. • Push the handle down to turn the water off.
Cleaning Recommendation for Hansgrohe Products Modern sanitary faucetry and shower fixtures consist of very different materials to comply with the needs of the market with regard to design and functionality. To avoid damage and returns, it is necessary to consider certain points when cleaning: Cleaning materials for faucets and shower products: Acids are necessary ingredients of cleaning materials for removing lime.
limitation, a commercial purpose, this warranty extends only (i) for 1 year, with respect to Interaktiv and Retroaktiv products, and (ii) for 5 years, with respect to AXOR, ShowerPower and Pharo products. THIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR: A. Conditions, malfunctions or damage not resulting from defects in material or workmanship. B.
