Owner manual

ManualsBrandsFactory Direct Hardware ManualsFor HomeHansgrohe 10313

06/04

Product Specification

Flow Rate Flow restricted to 2.2 GPM

Recommended Operating Pressure 14.7-72.5 PSI

Recommended Hot Water Temp Consult local codes

Elastop cartridge operation

Both rough-in and trim kit must be specified

Test pressure 235,2 PSI

Starck

Two-Handle Wall-Mounted Lavatory Faucet

10313XX1 Trim

10303181 Rough-in

Trim kit available in Chrome and Satinox

The Uniform

Plumbing Code

requires a minimum

of 1” from the

spout to the flood

level of the sink.

1”

Summary of content (4 pages)

PAGE 1
Starck Two-Handle Wall-Mounted Lavatory Faucet 10313XX1 Trim 10303181 Rough-in Trim kit available in Chrome and Satinox Product Specification Flow Rate Recommended Operating Pressure Recommended Hot Water Temp Elastop cartridge operation Both rough-in and trim kit must be specified Test pressure The Uniform Plumbing Code requires a minimum of 1” from the spout to the flood level of the sink. Flow restricted to 2.2 GPM 14.7-72.
PAGE 2
Assembly Large differences in pressure between the hot and cold water supply should be balanced.
PAGE 3
Limited Lifetime Consumer Warranty This product has been manufactured and tested to the highest quality standards by Hansgrohe, Inc. (“Hansgrohe”). This warranty is limited to Hansgrohe products which are purchased by a consumer in the United States after March 1, 1996, and installed in either the United States or Canada. WHO IS COVERED BY THE WARRANTY This warranty extends to the original consumer purchaser only. WHAT IS COVERED BY THE WARRANTY This warranty covers only your Hansgrohe manufactured product.
PAGE 4
TO OBTAIN WARRANTY SERVICE Contact your Hansgrohe retailer, or write to Technical Service at: Hansgrohe Inc. 1492 Bluegrass Lakes Parkway Alpharetta GA 30004 Or, call Hansgrohe toll-free at (800) 334-0455. In requesting warranty service, you will need to provide 1. The sales receipt or other evidence of the date and place of purchase. 2. A description of the problem. 3. Delivery of the product or the defective part, postage prepaid and carefully packed and insured, to Hansgrohe Inc.