Manualshelf

Installation Manual

ManualsBrandsFabtech ManualsAutomotiveFabtech FTS92031 Adjustable Track Bar fits only from 6-10” lifts
123456
3. Locate and remove the upper bolt and nut from the stock Track Bar. To remove the Track Bar pivot
bolt and nut, the front axle may have to be moved up or down to remove pressure from the Track Bar
bushing. Retain the factory hardware. SEE PHOTO BELOW.
4. Locate the lower pivot ball joint assemble at the axle end of the track bar. Remove the nut
attaching the bar to the ball joint in the axle. Retain the factory hardware and discard the factory
Track Bar SEE PHOTO BELOW.