Manualshelf

Installation Manual

ManualsBrandsFabtech ManualsAutomotiveFabtech FTS92031 Adjustable Track Bar fits only from 6-10” lifts
123456
TOOLS-
Assorted Metric & SAE Sockets & Wrenches
Torque Wrench, Jack, Jack Stands
READ ALL INSTRUCTIONS THOROUGHLY FROM START TO FINISH BEFORE BEGINNING
INSTALLATION! IF THESE INSTRUCTIONS ARE NOT PROPERLY FOLLOWED, SEVERE FRAME
DRIVELINE AND / OR SUSPENSION DAMAGE MAY RESULT.
CHECK FOR FRAME AND SUSPENSION DAMAGE PRIOR TO INSTALLTION. THIS KIT DOES NOT
REQUIRE WELDING FOR INSTALLATION. DO NOT WELD ANY OF THESE COMPONENTS.
THE INSTALLTION OF THIS KIT SHOULD BE PERFORMED BY A PROFESSIONAL MECHANIC.
INSTALLATION-
.
1. Locate the Fabtech Adjustable Track Bar and assemble the bar using the drawing below.
Set the adjuster sleeve with 5/8’’ of thread showing on both sides of the adjuster sleeve.
2. With the vehicle on level ground set the emergency brake and block the rear tires. Jack up the
front axle of the truck and support the frame rails with jack stands. NEVER WORK UNDER AN
UNSUPPORTED VEHICLE!