Installation Manual

ManualsBrandsFabtech ManualsAutomotiveFabtech FTS92031 Adjustable Track Bar fits only from 6-10” lifts

1

2

3

4

5

4331 EUCALYPTUS AVE. CHINO, CA 91710

909-597- 7800 Fax 909-597- 7185

Installation Instructions

FTS92030

2005 - 2013 0’’- 4’’ Ford 4WD Super Duty Adjustable Track Bar

PARTS LIST-

1 - FT30430BK Track Bar

1 - FT30414 Rod End

1 - FT30415 Adjuster Sleeve

1 – FT30429 Hardware Subassembly

FT30429 Hardware Subassembly

1 - Thread Lock

1 - FT30262-4 Sleeve

2 - FT30262-3 Bushing

FTS92031

2005 - 2013 6’’- 10’’ Ford 4WD Super Duty Adjustable Track Bar

PARTS LIST-

1 - FT30413BK Track Bar

1 - FT30414 Rod End

1 - FT30415 Adjuster Sleeve

1 – FT30429 Hardware Subassembly

FT30429 Hardware Subassembly

1 - Thread Lock

1 - FT30262-4 Sleeve

2 - FT30262-3 Bushing

Summary of content (6 pages)

PAGE 1
4331 EUCALYPTUS AVE.
PAGE 2
TOOLSAssorted Metric & SAE Sockets & Wrenches Torque Wrench, Jack, Jack Stands READ ALL INSTRUCTIONS THOROUGHLY FROM START TO FINISH BEFORE BEGINNING INSTALLATION! IF THESE INSTRUCTIONS ARE NOT PROPERLY FOLLOWED, SEVERE FRAME DRIVELINE AND / OR SUSPENSION DAMAGE MAY RESULT. CHECK FOR FRAME AND SUSPENSION DAMAGE PRIOR TO INSTALLTION. THIS KIT DOES NOT REQUIRE WELDING FOR INSTALLATION. DO NOT WELD ANY OF THESE COMPONENTS. THE INSTALLTION OF THIS KIT SHOULD BE PERFORMED BY A PROFESSIONAL MECHANIC.
PAGE 3
. Locate and remove the upper bolt and nut from the stock Track Bar. To remove the Track Bar pivot bolt and nut, the front axle may have to be moved up or down to remove pressure from the Track Bar bushing. Retain the factory hardware. SEE PHOTO BELOW. 4. Locate the lower pivot ball joint assemble at the axle end of the track bar. Remove the nut attaching the bar to the ball joint in the axle. Retain the factory hardware and discard the factory Track Bar SEE PHOTO BELOW.
PAGE 4
5. Install the New Fabtech adjustable Track Bar first at the lower pivot using thread lock and the factory nut. Tighten the nut to 183 ft-lbs. SEE PHOTO BELOW 6. Install the bushing end of the track bar into the drop bracket on the frame. Tighten to 406 ft-lbs.
PAGE 5
7. Center the axle accordingly using the adjuster sleeve on the track bar. After all adjustments have been made lock down the adjuster sleeve with the cross bolts. It is important that the sleeve is locked down with cross bolts perpendicular to the diff cover. SEE PHOTO BELOW 8. After the track bar is installed it may be necessary to a have vehicle Alignment preformed 9. Trimming of the cross member may be necessary to avoid contact with the new track bar.
PAGE 6
RETORQUE ALL NUTS, BOLTS AND LUGS AFTER 50 MILES AND PERIODICALLY THEREAFTER. For technical assistance call: 909-597-7800 Product Warranty and WarningsFabtech provides a Limited Lifetime Warranty to the original retail purchaser who owns the vehicle, on which the product was originally installed, for defects in workmanship and materials. The Limited Lifetime Warranty excludes the following Fabtech items; bushings, bump stops, ball joints, tie rod ends, limiting straps, cross shafts, heim joints.