Instructions / Assembly

18
MONOSLOPE PEAK
Notes:
1. Roofing underlayment not shown.
2. Apply sealant to the bottom of the foam closure and
position it on the roof panel approximately ½” - 1” back
from the edge of the flashing as shown.
3. Apply sealant to the top of the foam closure.
4. Install flashing as shown.
5. When more than one length of flashing is used, a 6”
minimum overlap is recommended. Apply sealant
between the lap
ENDWALL DETAIL
Notes:
1. Roofing underlayment not shown.
2. Install the foam closure as shown using sealant on the
top and bottom.
3. Install endwall flashing as shown.
4. When more than one endwall is needed, a 6” minimum
overlap is recommended with sealant between the laps.
SIDEWALL DETAIL
Notes:
1. Roofing underlayment not shown.
2. The sidewall flashing is placed over the panel rib and
placed behind the siding as shown.
3. When the panel rib does not end up next to the wall, cut
the panel and bend a 1” return flange.
SWEPT WING GABLE
Note:
1. In high rain & snow areas, FABRAL recommends that a
high-grade underlayment, such as ice and water shield,
be placed along the entire swept wing gable.
2. Roofing underlayment not shown.
3. Install the 1 x 1x 13’ sealer strip with a bead of butyl
sealant tape top and bottom.
4. Cut panels to fit the gable angle and align downslope
edge.
5. Fasten the panels through the flashing and into the deck
using #14 Mill Point screws per the standard eave
fastening pattern.
2" LONG FASTENER
A
T EVERY RIB
(9" O.C.)
OUTSIDE CLOSURE
SEALANT TAPE
TOP & BOTTOM OF
CLOSURE OR SEALER
STRIP
30# ROOFING FELT
29 GA. ARGI PANEL
CP-1
ROOF STRUCTURE
BUTYL TAPE
TOP & BOTTOM
OF CLOSURE
OUTSIDE CLOSURE
FLASH ASW-1
29 GA. AGRI PANEL
FASTENER
@ 9" C/C
ROOF SHEATHING
INSIDE CLOSURE
BUTYL SEALANT
TOP OF BOTTOM
OF CLOSURE
FASTENER
29 GA. AGRI PANEL
A
SW-1
FASTENER
@ 9" C/C
BUTYL SEALANT
ROOF FELT
BUTYL SEALANT TAPE
TOP & BOTTOM OF
SEALER STRIP
SEALER STRIP
(ASPHALT IMPREGNATED)
FASCIA BOARD
CE-1 FLASH
FASTENER