Instructions / Assembly
32
Fabral.com
KEY TERMS
See page 16 for Illustration of Trim Conditions
Key Terms
CHIMNEY OR SKYLIGHT
See pages 23-26.
EAVE TRIM
This piece is used at the eave or gutter edge of the building, and must be installed before any panels.
ENDWALL
This piece is used when the upper end of panel butts into a vertical wall.
HIP CAP
This piece covers projecting angles formed at the intersection of the two sloping roof planes.
FASTENERS
3/4” Stitch Screw
This fastener is used to attach two pieces of metal to each other.
#14 x 1” Mill Point
This fastener is used to fasten into panel near ridge, and can also be used for secure ashings and
pipe boots.
#10 x 1” Wafer Head Screw
This fastener is used to attach roong panels to the roof deck. (Used to fasten into HORIZON S
fastener strip.)
#10 x 1” WoodFast
This fastener is used to fasten ashing to fascia boards at eave or gable.
GABLE TRIM
This piece is installed on the house between the ridge and the eave, holding down the rst panel edge and
the last panel edge.
GAMBREL CONDITION
This trim is used to transition from a low slope on the upper roof to a steep slope on the lower roof.
MONOSLOPE RIDGE
This piece is used at the top of a single sloped roof.
RIDGE CAP
This piece is used at the peak of the roof. The ridge can be ventilated by leaving the foam closure out.
SIDEWALL
This piece is used when the roong panel is installed parallel to a vertical wall.
SLOPE TRANSITION
This piece is used where two roofs of different pitch meet; the top section being steeper than the lower
section.
W-VALLEY
Used to ash the valley formed by intersecting roof planes.