Instructions / Assembly

9
SAMPLE D
Section A 24 pcs. X 10’
1 pc. X 8’-7”
1 pc. X 7’-2”
1 pc. X 5’-9”
1 pc. X 4’-4”
1 pc. X 2’-11”
1 pc. X 1’-6”
1 pc. X 1’-0”
Step 3
Refer to the Home Legend of page 16 for trim placement. From this diagram, you can determine
the names and placement of the trim needed. All trim is produced in 10’6” sections only. Re-
member to allow 6” of overlap on all trims. Use the estimating section to determine trim quanti-
ties.
For applications of trims and ashings, see pages 17-26.
Calculate total lineal feet of panels = (pcs x ft-inches) total sum = _______ ln ft.
Use on next page for number of screws needed.
Accessories
Determine total lineal feet of conditions listed below and then ll that number in accordingly at
each spot listed, Perform calculating to determine number of pieces for each item and circle ash-
ing design required.
Eave ___________ Ridge____________
Hip_____________ Gable ____________
Sidewall Endwall___________
Valley___________ Transition _________
Gambrel ________ Swept Wing or Flying Gable ___________
Clear Story __________ Roof Pitch ________“ in 12”
Chimney (Qty. and size) ___________ Skylight (Qty. and size) ___________