Instructions / Assembly

HORIZON S TRIM DETAILS

Fabral.com

SKYLIGHTS

View installation videos at Fabral.com/videos

PROCEDURE FOR THE INSTALLATION OF SKYLIGHT FLASHING

Notes:

1. Do not fasten down the panels a minimum of 24” uphill from the skylight.

2. Whenever possible, position the skylight curb so the ribs of the roof panels do not interfere with the ash-

ing.

3. Cut the HORIZON S panels as close to the left, right and downhill sides of the curb as possible. Cut the

uphill side 6” up from the curb as indicated above.

Notes:

1. The skylight ashing will be 4” wider than the width

of the curb (2” on each side).

2. Cut a 1/8” slot in the two uphill corners of the

HORIZON S panels, slightly wider than 2” so the uphill ash-

ing can slide through the two slots.

Note: Contact Fabral regarding skylight details when sky-

light is downslope more than 10 ft. down from ridge. Appli-

cations where this is present may cause panel distortion due

to thermal movement.