Instructions / Assembly
7
Step 2
With the information from the diagram you completed in Step 1, you are now ready to complete
your roong panel cut list. Each panel is 16” wide so the only measurement you need is the dis-
tance from the eave to the ridge. You can then determine the number of panels needed to cover
the length from gable to gable. (See example Diagram A below.)
DIAGRAM A
25'
25'
12'
12'
EA VE
EA VE
RIDGE
GAB LE GAB LE
GAB LEGAB LE
Se ct io n A
Se ct io n B
The length from the eave to the ridge is 12’. The length of the ridge is 25’; therefore, the number
of panels to complete one side of the house is 25’ ÷ 1.33’(16”)= 19 pcs. Your materials list should
look like Sample B.
SAMPLE B
Section A - 19 pcs. X 12’
Now look at your roof diagram and gure out your next section of roof. Refer back to Diagram
A. Section B of this sample roof is the same as Section A. Your materials list should now look like
Sample C below.
SAMPLE C
Section A—19 pcs. X 12’
Section B—19 pcs. X 12’
If your home has hips or valleys, refer to Diagram 1A on page 8.