Installation Instructions + Use and Care Manual

28
Cleaningmetalgreaselters
Thesecanbewashed inthedishwasher,andneedtobe
cleanedwhenevertheS1Ledcomesonoratleastonceevery2
monthsofuse,ormorefrequentlyifuseisparticularlyintensive.
Resetting the Grease Filter Alarm
• TurntheLightsandtheHoodoff.
• PressT3andholdforatleast3seconds,untilLEDashes
threetimesinconrmation.
Cleaning the Filters
• OpenthePanel.
• RemovetheFiltersoneatatime,pushingthemtowards
thebackoftheunitandatthesametimepullingdownward.
• WashtheFilterswithoutbendingthem,andleavethemto
drycompletelybeforereplacing.(Ifthesurfaceofthelter
changescolorastimegoesby,thiswillhaveabsolutelyno
effectontheefciencyofthelteritself.)
• Replacethegreaselters,takingcaretoensurethatthe
handlefacesforward
• ClosethePanel.
• 4Filters-48"model,3Filters-36"model.
Replacing Activated Charcoal Filter
Theycannotbewashedorregenerated,andmustbechanged
whenledS1startstoash,oratleastonceevery6months.
TheAlarmsignal,ifithasbeenactivated,onlyappearswhen
theHoodBloweristurnedon.
Resetting the alarm signal
• TurntheLightsandtheHoodBloweroff.
• PressT3andholdforatleast3seconds,untilLEDashes
threetimesinconrmation.
Cleaning the Filters
• OpenthePanel.
• RemovetheMetalGreaseFilter.
• Remove the saturated Activated Charcoal Filters, as
indicated(A).
• FitthenewFilters,asindicated(B).
• ReplacetheMetalgreaselters.
• ClosethePanel.
Lighting unit
• LEDlightsmustbereplacedbyFaberfactoryauthorized
service.
A
B