Spec sheet
Rev. 3/15
WARNING! Product specifications are subject to change without notification. Consult the installation instructions for both the remote blower and the ventila-
tion system before you begin installing this range hood. Consult cooking manufacturer instructions for cut out dimensions, clearances and CFM requirements.
Top trim widths:
30 " (762 mm) vent
36 " (914 mm) vent
14 " (357 mm)
retractable
vent height
27" (686 mm) for 30" (762 mm) vent
33" (838 mm) for 36" (914 mm) vent
13" (330 mm)
10 "
(254 mm)
21⁄8 " (54 mm)
283⁄4"
(730 mm)
3⁄8" (9.5 mm)
11⁄2 " (38 mm)
13" (330 mm)
Terminal box cover
6" (152 mm)
diameter
vent collar
x
Note: Overall dimensions show unit with
internal blower box attached. Remote
Blower would only have a vent collar
attached instead of the 13” x 13” box shown.
X = Distance to the rear of the cabinet
or wall. Must be a minimum of ½”.
When mounted on the front of the hood, the Internal blower
box can be rotated to vent left, right, down or thru the hood to
the rear of the unit. When mounted on the back of the hood,
the blower can be vented left, right or down. The remote blower
venting can come out the front or back of the unit venting
down. Note: A clearance of 3/4” is required in front of the
hood when mounting the blower on the back.
FRONT
BACK
Motor on Front
Motor on Back
Right Vent
Left Vent
Bottom Vent Direct Rear Vent
Dimensional Diagrams
(see installation instructions for more information)
ACCESSORIES
Satisfies current make-up air requirements, this kit
uses an air switch above the hood to activate the
make-up air damper to open and bring fresh air into
the home whenever the hood fan is operating and
then close tightly when the hood is off. The CFM
level is not reduced by using this kit.
Universal Make-Up Air Damper
# MUDAMPER6 / MUDAMPER8 / MUDAMPER10
(6”) (8”) (10”)