Installation Instructions

Version 6/12 - Page 19
DOWNDRAFT SYSTEM CARE
Surface of Downdraft Vent
To avoid damaging the nish, clean
downdraft vent with soap and water or
Stainless steel cleaner.
Do not use scouring powder or abrasive
solutions.
Grease Filter Care
Frequently remove and clean the lters in the
retractable section of the downdraft vent. This
will improve the operating efciency of the
downdraft vent system.
To Remove Filters:
1. Place ngertips in the embossment at the
top for the lters.
2. Press down on the lters far enough for the
tab at the top of the lters to clear.
3. Pull forward to release the lter from its
groove.
To Clean:
1. Remove the lters and clean them in a
dishwasher or in a hot detergent solution.
The downdraft vent will not operate when the
lters are not in place.
2. Dry the clean lters and reinstall, making
sure that they lock into place.
To Replace Filters:
1. Place lters into the retractable section of
the downdraft vent.
2. Place ngertips into the embossment at the
top of the lters and push down and back to
allow the top tabs to snap in place.
NOTE: Downdraft vent will not operate if the
lters are not in their proper position. If the
lters top tabs are not locked behind the top
ange, the vent may retract but not raise back
up.
If retractable downdraft vent does not
operate after clean lters have been
installed:
Push the lter in as far as it will go. When the
lter is removed, the microswitch behind the
lter is inactivated. This feature will not
allow the vent system to operate until the lter
is properly installed.
A- Grease lter removal tab
B - Left grease lter
C - Right grease lter
WIRING DIAGRAM