Installation Instructions

Version 6/12 - Page 12
PRODUCT INSTALLATION CONTINUED
FIGURE 14
FIGURE 15
8) Remove the screws from the countertop
and lift the hood back out of the cabinet.
Pre-drill the marked mounting holes in the
cabinet oor.
9) Tighten the mounting brackets on the
hood at the pre-marked positions
10) Lay the hood on the oor on a
protected surface to prevent damage in
order to install the motor. At this point
the ductwork venting direction should be
decided (thru the oor, right, left or thru the
rear of the cabinet).
IF USING A REMOTE BLOWER, TURN
TO "REMOTE BLOWER INSTALLATION
ON PAGE 15
- See FIGURE 14 for venting left, right or down.
Plug in the wiring cable from the motor kit to the
hood.
- Turn the venting collar on the blower box to the
desired direction - left, right or down.
- Mount the blower box to the housing using 4
screws (FIGURE 15)
Continue to Page 14 for Electrical
Connections
INSTALLING IB500 IN FRONT OF THE HOOD