Make Up Air Comparison

MAKEUPAIRINSTALLATION

FABER

STEP1–Placetheswitchductpieceon

topofthehoodandtapeinplace

STEP2– Connectlowvoltagewiringto

theswitch,tothetransformerandto

theexternaldamper

STEP3–Enjoyyourhood!

OTHERS

STEP1– Drill3/8”holeintotheducting

STEP2–Attachprobeandgasketintotheholes

withscrewsincorrectposition

STEP3–Attachthetubetothesensorongrey

inletconnector

STEP4–inserttubeintoductpointingdown

STEP5–Attachthepressureswitchwithsheet

metalscrews

STEP6– Connectlowvoltagewiringtothe sensor,

tothetransformerandtotheexternaldamper

STEP7–BeadvisedofpossibleFalsetripping

Undercertainextremeconditionsthere

couldbefalsetrippingofthedamper

(openingwhentherangehoodbloweris

off).Iffalsetrippingisencountered,place

anin‐linebackdraftdamper(7”modelno.

97,8”modelno.438,10”modelno.421)

betweentheprobeandtherooforwall



cap.

PAGE 1
MAKE UP AIR INSTALLATION FABER STEP 1 – Place the switch duct piece on top of the hood and tape in place STEP 2 – Connect low voltage wiring to the switch, to the transformer and to the external damper STEP 3 – Enjoy your hood! OTHERS STEP 1 – Drill 3/8” hole into the ducting STEP 2 – Attach probe and gasket into the holes with screws in correct position STEP 3 – Attach the tube to the sensor on grey inlet connector STEP 4 – insert tube into duct pointing down STEP 5 – Attach the pressure switch with shee