Installation instructions

Version07/11-Page9
INSTALLATION WITH IB1200 INTERNAL BLOWER (1200 cfm)
1. InstallthePlateB(FIGURE14)whichcamewiththeinternal
blowerkit,ontopoftherangehoodwiththeholeslocatedcloserto
thefront.Use9screwssuppliedwiththeblowerkit
2. RemovethewhiteplasticcoveringandInstallthe4sidetrim
piecestotheoutsideofthehoodusing(16)part9bscrews,see
thesiderailinstallationin(FIGURE15).
3. Attachtheblowerbracketdividerinsidethehood,withthe2
screwsintothetopofthehoodand2screwsintotheback,all
suppliedwiththeblowerkit(FIGURE16)
FIGURE 16
FIGURE 17
4. Installthe2motorkitsintothesidesoftheblowerbracketusing
the4screwssuppliedwiththemotorkit.(FIGURE17)
5.Connectthewire(FIGURE18)thatcomeswiththemotorkit
from the side of the two motors to the connection on the inside
ofthelightpanelinthehood.Thetwo-9holeendsofthewire
areinstalledinthetwomotors,the6holeendisconnectedto
thelightpanel(FIGURE11onthepreviouspage)
FIGURE 15
FIGURE 18
FIGURE 19
6. Installthe2dampersontopofthehood. Ifyouwantone10"
roundducttocomeoutofthetopofthehood,usethetransition
piece(FIGURE19)thatcomeswiththemotorkitandinstallwith
fourscrews.Ifyouwanttouse2seperate6"roundducts,donot
use the transition.
7. Attachthehoodtothecabinetusing(12)9c.screwstothe
cabinet.FIGURE20
8.Followsteps6-9onthepreviouspagetoconnectducting,
wiring,andtesttheelectricalconnection.
FIGURE 14
FIGURE 20
B