Installation Instructions and Use and Care Info

8
0LQ
´


´


´
1
2
Cut out
the open-
ing in the
underside
of the
cabinet as
shown in
Figure 1.
Remove the three lters from the
Insert Hood before installing into
cabinet.
Installation Instructions
3.a
Install Roof or Wall Cap
purchased separately.
Connect the 6" metal
ductwork to the Roof or
Wall Cap and then attach
ductwork.
Vertical Ducting Installation
EN
7
7
INSTALLATION
Fitting the Hood canopy
BEFORE FITTING THE HOOD TO THE WALL UNIT, PROCEED AS FOLLOWS:
• Disconnect the wires to the Commands at the connectors.
• Disconnect the wires to the Light at the con-
nectors.
• The Hood can be installed directly on the
underside of
the wall unit (Minimum 650 mm
from the Cooker Hob).
• Create an opening in the bottom of the wall unit,
as shown.
• Insert the hood until the side supports snap into
place.
• Fasten using the 10 screws 12a provided.
• Lock in position by tightening the screws Vf from
underneath the hood.
• Open the suction panel by turning the specific knob.
• Disconnect the panel from the hood canopy by sliding the
fixing pin lever.
• Remove grease filters.
• Screw the Frame into place
using the 6 scr
ews 12f, re-
connect the wires to the
Commands and Light, re-
place the metal grease filter
and the Panel.
260
13
495 - 675