Installation Guide

14
USE AND CARE INFORMATION
For Best Results
Starttherangehoodseveralminutesbeforecookingtodevelopproperairow.Allowtherangehoodto
operate for several minutes after cooking is complete to clear all smoke and odors from the kitchen.
       
Button Function Display
A Turns the suction motor on and off at speed one. Displays the set speed
B Decreases the working speed. Displays the set speed
C Increases the working speed. Displays the set speed
D Activate intensive speed from any other speed,
including motor off. This speed is set to operate for
6 minutes, after which the system returns to the
speedthatwassetbefore.Suitabletodealwith
maximum levels of cooking fumes.
Displays HI and the time remaining once very
second.
Press and hold the button for approximately 5
seconds, with all the loads turned off (Motor and
Lights), to turn the Activated Charcoal Filter alarm
On and Off.
FC+Punto(2ashes)–AlarmOn.
FC+Punto(1ash)–AlarmOff.
E
24H function
Turns the suction motor on at speed one and effects
one 10 minute extraction every hour.
Displays24andthespotatthebottomrightashes
once every second, while the motor is running.
It is disabled by pressing the button.
Whentheltersalarmistriggered,thealarmcan
be reset by pressing and holding this button for
approximately 3 seconds.
These indications are only visible when the motor
is turned off.
FFashesthreetimes.
When the procedure terminates, the indication
shown previously turns off:
FG indicatestheneedtowashthemetal
greaselters.ThealarmistriggeredaftertheHood
has been in operation for 100 working hours.
FC indicates the need to change the
activatedcharcoallters,andalsotowashthe
metalgreaselters.Thealarmistriggeredafterthe
Hood has been in operation for 200 working hours.
F Delay function
Activate automatic switch-off with a 30’ delay.
Suitabletocompleteeliminationofresidualodours.
Can be activated from any position, and is disabled
by pressing the button or turning the motor off.
Displays the operating speed and the spot at the
bottomrightashesonceasecond.
Press and hold the button for approximately 5
seconds, with all the loads turned off (Motor and
Lights), to turn the Remote Control On and Off.
IR+Punto(2ashes)–RemoteControlOn.
IR+Punto(1ash)–RemoteControlOff.
G
Turns the lighting system on and off at maximum
intensity.
H
Turns the Courtesy Lighting on and off.