Safety data sheet

Safety Data Sheet
according to Regulation (EC) No. 1907/2006
FabConstruct 3D SCANNING SPRAY (Mattierungsspray)
5Page v. 11
Hand protection
The quality of the protective gloves resistant to chemicals must be chosen as a function of the specic working place
concentration and quantity of hazardous substances.
Recommended protective gloves brand: (Break through time > 480 min)
NBR (Nitrile rubber). (0,35 mm)
Butyl rubber. (0,5 mm)
FKM (uororubber). (0,4 mm)
Recommended protective gloves brand: (Break through time > 240minutes.)
CR (polychloroprenes, Chloroprene rubber). (0,5 mm)
Unsuitable material:
NR (Natural rubber (Caoutchouc), Natural latex). PVC (Polyvinyl chloride).
For special purposes, it is recommended to check the resistance to chemicals of the protective gloves mentioned above together
with the supplier of these gloves.
Protect skin by using skin protective cream.
Skin protection
Body protection: not required.
Respiratory protection
With correct and proper use, and under normal conditions, breathing protection is not required.
Respiratory protection necessary at: exceeding exposure limit values
Suitable respiratory protection apparatus: Filter type: A (colour: brown)
Environmental exposure controls
No information available.
9. Physical and chemical properties
9.1. Information on basic physical and chemical properties
Physical state: Aerosol
Colour: white
Odour: characteristic
pH-Value: not determined
Changes in the physical state
Melting point: not determined
Initial boiling point and boiling range: not determined
Flash point: not determined
Flammability
Solid: not applicable
Gas: not applicable
Explosive properties
Heating causes rise in pressure with risk of bursting. Vapours may form explosive mixtures with air.
Lower explosion limits: not determined
Upper explosion limits: not determined
Auto-ignition temperature
Solid: not applicable
Gas: not applicable
Revision date: 02.06.2017