Safety data sheet
Safety Data Sheet
according to Regulation (EC) No. 1907/2006
FabConstruct 3D SCANNING SPRAY (Mattierungsspray)
3Page v. 11
After contact with skin
Wash with plenty of water. Change contaminated clothing.
After contact with eyes
If product gets into the eye, keep eyelid open and rinse immediately with large quantities of water, for at least 5
minutes. Subsequently consult an ophthalmologist.
After ingestion
Rinse mouth immediately and drink plenty of water. Medical treatment necessary.
4.2. Most important symptoms and effects, both acute and delayed
Following inhalation: Headache. drowsiness. Dizziness.
4.3. Indication of any immediate medical attention and special treatment needed
Treat symptomatically.
5. Fireghting measures
5.1. Extinguishing media
Suitable extinguishing media
Co-ordinate re-ghting measures to the re surroundings.
5.2. Special hazards arising from the substance or mixture
Vapours may form explosive mixtures with air. Heating causes rise in pressure with risk of bursting.
5.3. Advice for reghters
In case of re: Wear self-contained breathing apparatus.
Additional information
Suppress gases/vapours/mists with water spray jet. Collect contaminated re extinguishing water separately. Do not allow entering
drains or surface water.
6. Accidental release measures
6.1. Personal precautions, protective equipment and emergency procedures
Remove all sources of ignition. Provide adequate ventilation. Do not breathe gas/vapour/aerosol. Avoid contact with
skin, eyes and clothes.
6.2. Environmental precautions
Do not allow uncontrolled discharge of product into the environment.
6.3. Methods and material for containment and cleaning up
Ventilate affected area.
Flammable liquids: Absorb with liquid-binding material (e.g. sand, diatomaceous earth, acid- or universal binding agents).
6.4. Reference to other sections
Treat the recovered material as prescribed in the section on waste disposal.
Revision date: 02.06.2017