Use and Care Manual

Acrylic Mirror Care Manual
Handling:
All FABBACK
®
acrylic mirror sheets are furnished with protective masking
on the reflective side of the sheet. Do not slide mirror when transporting
and always store acrylic mirror in a clean, dry location with masking left
in place until the sheet is ready to use.
Vertical Storage:
If mirror sheets are to be stored or transported on end
(vertically), care must be taken to avoid warping. Sheets must
stand with an angle no more than 10 degrees from vertical. Care
should be taken to make sure the sheets are properly supported.
Always store sheets with factory applied masking until ready for
use.
Horizontal Storage:
If mirror sheets are to be stored or transported flat (horizontally),
care should be taken to avoid warping, sliding and scratching. If
different sizes are being stored together, make sure that largest
sizes are at the bottom with smaller sizes stacked on top. Be sure
to keep debris from settling between sheets, this may cause
scratching. Always store material with factory applied masking until
ready for use.
Maintenance:
Each sheet is well protected by a durable paint backing and removable
masking on the reflective side. Masking should remain in place to protect
sheets during the fabrication or installation process. If there is difficulty
removing the masking, use aliphatic naptha, kerosene, or distilled
alcohol. Do not use other chemicals or sharp objects to remove masking.