Owner's Manual

6
ADJUSTING THE CAST:
1. Engage the safety.
2. Unload the shotgun.
3. Take out the cheek piece.
4. Loosen the fixing bolts - D - with the Allen key. (FIG.31)
5. Move the fixing bolts to the left or to the right. (FIG.32)
6. Retighten the bolts and refit the cheek piece.
STOCK MODIFICATION (DROP AND DEVIATION)
The stock incorporates a shim system for adjusting drop and cast as it’s indicated
on FIG.33.
Please see your gun dealer.
BALANCING WEIGHT SYSTEM
There is a standard weight system built on the magazine cap that allows the
shooter to alter the weight up to 4 ½ ounces in 1 ½ once increments.
1. Place a weight into the magazine cap.
2. Screw it in clockwise until tight. Make certain it is tight using the Allen
wrench. (FIG.34)
3. Repeat the procedure to fit other balancing weights.
KINETIC RECOIL REDUCERS
For shotgun equipped with this option, there is a stock kinetic recoil reducer
installed on the stock connecting rod. It has a weight of approximately 150 g (5.35
oz).
Please see your gun dealer.
INTERCHANGEABLE RECOIL PAD
The XLR stock is using HRA™ recoil pads, fully interchangeable without any
adjustment. To adjust the length-of-pull these pads are available in various
thicknesses and profiles.
Please contact your gun dealer.