Owner's Manual

ADJUSTABLE TOP RIB

The rib elevation is easily adjusted with a small thumb wheel at the muzzle end,

so that the point-of-impact is adjustable from 50/50 % to 90/10 % pattern without

the use of tools.

1. Engage the safety.

2. Unload the shotgun.

3. To move the rib up, press lightly the rib to the barrel with your left hand.

(FIG.22)

4. Turn the small finger wheel to the right (clockwise) and release the rib

going up. (FIG.23)

With the rib adjusted all the way to the upward position the point-of-impact

will be 50/50% at 35 meters as shown on FIG.24.

5. To move the rib down, reproduce the procedure, turning the finger wheel

to the left (counter-clockwise).

With the rib adjusted to lowest setting the point-of impact will be 90/10%

at 35 meters as shown on FIG.25.

Once the desired height has been set, achieving the desired point-of-

impact, the anti-rotation system on the finger wheel will keep it fixed

without the use of tools.

ADJUSTABLE STOCK “MICRO-METRIC 3D”

ADJUSTING THE DROP:

1. Engage the safety.

2. Unload the shotgun.

3. Using the appropriate Allen wrench, loosen the screws - A - so the cheek

piece can slide free of the butt stock. (FIG.26)

4. Turn the part - B - counter-clockwise, using if necessary the small Allen

key as shown on FIG. 27.

5. Turn clockwise ( to reduce the drop ) or counter-clockwise ( to increase

the drop ) the two parts – C - (FIG.28).

6. Making sure that the parts - C- are oriented as shown on FIG.29, screw

again the part - B - so that it comes in contact under the part - C - to

perfectly lock it.

7. Refit the cheek piece back on the butt stock by sliding it down on the

support posts. (FIG.30)

8. Using the appropriate Allen wrench, retighten the lock screws - A -.