Owner's Manual

4
6. The trigger group can be removed by pulling outward. (FIG. 16)
MAINTENANCE AND CLEANING
The proper maintenance and cleaning of your shotgun will enhance the
performance and extend the service life of your FABARM shotgun.
BARREL: Wet a patch with bore cleaning solvent and wet the inside of the bore
by pushing the wet patch through from the chamber end of the barrel.
BOLT & GAS PISTON: The bolt and the gas piston are important components
and must be cleaned thoroughly. A good gun oil and bristle brush should clean it
sufficiently.
Avoid over-lubrication. A thin coat of FABARM gun oil will help prevent rust.
SHOTGUN REASSEMBLY
1. Put the recoil spring back in place on the magazine tube.
2. Place the bolt assembly on the end of the action bar and don’t forget to
put the locking bolt in position first. (FIG.17)
3. Guide the assembly into the tracks on both sides of the receiver and snap
the cocking handle into position. (FIG.18)
4. Reinstall the trigger guard assembly and install the two trigger guard
retaining pins. (FIG.19)
5. Install the piston with the hollow end forward, install the barrel, after which
slide the fore-end on the magazine tube and screw on the fore-end cap.
ADJUSTABLE TRIGGER
For shotgun equipped with an adjustable trigger for length-of-pull.
1. Engage the safety.
2. Unload the shotgun.
3. Using the appropriate TORX wrench, loosen the lock screw which is on
the trigger. (FIG.20)
4. Slide the trigger and put it on your preferred position. (FIG.21)
5. Using the appropriate TORX wrench, retighten the lock screw.