Owner's Manual

REMOVING/INSTALLING CHOKE TUBES

WARNING: Unload the firearm before changing choke tubes. Leave the action

open and the chamber and magazine empty when changing choke tubes.

1. Engage the safety switch.

2. Place the choke tube wrench into the choke tube.

3. Turn the wrench counter-clockwise to remove the choke tube.

4. Select the desired choke tube and insert the tube into the barrel.

5. Screw it in clockwise until tight. Make certain it is tight using the choke

wrench but do not over tighten. A small amount of lubricant on the threads

will ensure the choke tube can be installed and removed with ease.

6. With the action open and the chamber and magazine empty, check the

choke tube occasionally to make sure the tube has not loosened.

NEVER USE THE BARREL WITHOUT ANY CHOKE TUBES.

CHOKE TUBES:

This XLR shotgun is delivered with EXIS HP choke tubes

(Hyperbolic profile)

MODEL USE

EXIS skeet For very short distances / skeet

EXIS HP SHORT 2/10 For short distances

EXIS HP MEDIUM 5/10 For medium distances

EXIS HP LONG 7/10 For long distances

EXIS HP XTREME 9/10 For extra-long distances

STEEL SHOT: STEEL SHOT AMMUNITION can be used in your XLR shotgun,

with all chokes tighter than MEDIUM, even the XTREME.

DISASSEMBLY

1. Place the shotgun on safe and ensure that it is completely unloaded.

2. With the bolt closed, unscrew the fore-end cap and remove the forend.

Then carefully remove the barrel. The gas piston slides off the front of the

magazine cap shaft.

3. Using the ring of an empty shell, carefully pry the cocking handle out and

remove it as show in. (FIG.13)

4. Remove the action bar bolt group assembly. (FIG.14)

5. With a pin punch tap out the two trigger guard pins. (FIG.15)