Owner's Manual

8
b- Your weapon has a magazine tube extension: in this case, put the
magazine spring in the tube then place the extension at the end of
the spring.
c- Compress the spring by pressing on the extension until you can
screw the extension onto the magazine tube end threading (fig.5).
d- If your magazine extension has an interface fixed on the barrel,
position the attaching interface B-191-A between the barrel and the
extension and use a suitable Allen key to tighten the attaching screw
(fig.6).
A mark on the extension indicates where to position the interface.
LOADING THE SHOTGUN.
1. Before loading the shotgun, engage the safety by pressing the safety
button so that the red line is no longer visible.
2. Press the unlocking lever in front of the trigger guard (fig.7).
3. Slide the forend back to open the shotgun (fig.8).
4. Insert a shotshell into the chamber, through the ejection window (fig.9).
5. Slide the forend forwards. This operation locks the breech bolt inside the
barrel.
6. Turn the weapon over then, using your thumb, feed the ammunitions in one
by one, pressing down on the carrier to reach the magazine tube (fig.10).
FIRING
1. Aim the shotgun at the target.
2. Take off the safety.
3. Pull the trigger.
4. After firing the first shotshell, slide the forend back to eject the shotshell
case you just fired before.
5. Slide the forend forwards to feed a new shotshell into the chamber.
6. Repeat this pumping action after each shot. Release the trigger after
each shot and pull it to fire again.
7. After firing the last shotshell, make sure that the weapon is absolutely
empty by inspecting the chamber and the magazine tube. You should be
able to see the red cap in the magazine tube.
UNLOADING THE SHOTGUN
1. Point the weapon in a safe direction.
2. Engage the safety by pushing on the button.
3. Press the unlocking lever and slide the forend backwards and forwards
in an alternating movement. (fig.11)