Owner's Manual

REASSEMBLY

1. If the locking lug has been removed, start by putting the lug on the

bolt (fig.19).

2. Place the firing pin and its spring into the bolt then compress it to bring

the retaining pin into place (fig.20).

3. Put the bolt on the action bar (fig.21).

4. Check that the hammer is in the cocked position (fig.22), if it is not push

it back until it locks into the cocked position.

5. Insert the complete action bar with bolt into the frame, positioning the

action bar to face the slides located inside the frame (fig.23).

6. Position the front of the breech bolt so that it aligns with the edge of the

frame by pushing the forend forwards or backwards (fig.24).

7. Continue to assemble, following the instructions given in the

“ASSEMBLY THE SHOTGUN “section.