Instruction manual

7
6
4. With a pin punch tap out the two trigger guard pins ( FIG.18 ).
The trigger group can be removed by pulling outward ( FIG.19 ).
MAINTENANCE AND CLEANING
The proper maintenance and cleaning of your shotgun will enhance the performance and extend the
service life of your FABARM shotgun.
BARREL : Wet a patch with bore cleaning solvent and wet the inside of the bore by pushing the wet
patch through from the chamber end of the barrel.
BOLT & GAS PISTON : The bolt and the gas piston as important components must be cleaned
thoroughly. A good gun oil and bristle brush should clean it sufficiently.
Avoid over-lubrification. A thin coat of FABARM gun oil will help prevent rust.
SHOTGUN REASSEMBLY
1. Put the recoil spring back in place on the magazine tube.
2. Place the bolt assembly on the end of action bar and don’t forget to put the locking bolt in
position first ( FIG.20 ).
3. Guide the assembly into the tracks on both sides of the receiver and snap the cocking handle
into position ( FIG.21 ).
4. Reinstall the trigger guard assembly and install the two trigger guard retaining pins ( FIG.22 ).
5. Install the piston with the hollow end forward, install the barrel, after which slide the forend on
the magazine tube and screw on the forend cap ( FIG.23 ).
STOCK MODIFICATION (DROP AND DEVIATION)
On XLR shotguns, a set of stock spacers give the possibility to modify the drop and the deviation of the
stock as it’s indicated on the FIG.24
Please see your gun dealer to fit a new spacer if needed.
KINETIC RECOIL REDUCERS
On XLR shotguns it’s possible to install a stock kinetic recoil reducer on the stock connecting rod.
Please see your gun dealer.
MAGAZINE EXTENSION
A magazine extension can be fitted on the XLR COMPOSITE , to obtain a 8 shots configuration.
Unscrew the magazine cap.
Take out the magazine spring retainer with a screwdriver and maintain the spring in the magazine
( FIG.25 )
Place the extension on the tube and screw it ( FIG.26 )