User Manual

ADJUSTABLE OPENING TENSION
This mechanism gives the possibility to change the pressure of the forend bracket
on the barrel tenon. So, according to the desire of the users, or after an intensive
use, it’s possible to modify the resistance of the barrel rotation around the hinge
pin.
1. Using the appropriate ALLEN wrench, loosen the lock screw (FIG.11)
2. Using the other appropriate ALLEN wrench, turn slowly the eccentric screw
(FIG.12).
3. Retighten the lock screw (FIG.13).
4. Pull back the forend to lock the forend bracket on the barrel (FIG.14).
5. Reproduce the operation if the opening resistance still not tight enough or if
the forend catch cannot be locked on the barrel.
ADJUSTABLE TRIGGER
The shotguns are equipped with an adjustable trigger under 4 positions.
1. Using the appropriate ALLEN wrench, loosen the lock screw which is on the
trigger (FIG.15)
2. Slide the trigger and put it on your preferred position (FIG.16)
3. Using the appropriate ALLEN wrench, retighten the lock screw.
KINETIC RECOIL REDUCERS
On the competition shotguns, it’s possible to install a stock kinetic recoil reducer
(weight 200 gr).
You can fit the reducer in the stock connecting rod after took out the pad. Please
contact your gun dealer.
FOR SHOTGUNS WITH ADJUSTABLE STOCK “MICRO-METRIC 3D”
ADJUSTING THE DROP
1. Using the appropriate ALLEN wrench, loosen the screws - A - so the cheek
piece can slide free of the butt stock (FIG.17).
2. Turn the part - B - counter-clockwise, using if necessary the small ALLEN key
as shown on the FIG.18.
3. Turn clockwise (to reduce the drop) or counter-clockwise (to increase the
drop) the two parts - C - (FIG.19).
4. Making sure that the parts - C - are oriented as shown on the FIG.20, screw
again the part - B - so that it comes in contact under the part - C - to perfectly
lock it.