Instruction manual

WARNING: ALWAYS WAIT UNTIL YOU ARE READY TO FIRE
BEFORE COCKING THE RIFLE.
FIRING AND REPEATING
1. Cock the rifle by pushing hard the safety slide forward until it engages, so
that only the red dot is visible. (Fig.24)
2. Sight the target and fire.
3. Take the bolt lever in hand and move it upward for 60 °. Then pull it back
as far as the bolt stop allows so that the spent cartridge shell will be
extracted and ejected. (Fig.25)
4. Then push it forward again to feed a new cartridge into the chamber.
Relock the action by turning the bolt lever down. (Fig.26) The rifle is now
ready to fire again.
WARNING: WHEN THE SAFETY SLIDE IS LOCKED IN ITS
FORWARD POSITION ( ONLY THE RED DOT IS VISIBLE ) THE
RIFLE IS AUTOMATICALLY COCKED AFTER EACH REPEATING.
UNLOADING THE RIFLE
1. Pull the bolt back as far as the bolt stop allows so that the cartridge which
was in the chamber will be extracted and ejected. (Fig.27)
2. When the rifle is uncocked ( red and white dots visible ) (Fig.28) to open
the bolt, you should press forward for few millimetres the safety slide and
turning at the same moment the bolt lever upward.
3. When the rifle is cocked ( only the red dot is visible ) there is no necessity
to press forward the safety slide. Move directly the handle
upward/backward to open the rifle.
4. Keep the bolt opened.
5. Press the two latches at the right and left of the magazine together and
using the thumb and index finger, remove the magazine. (Fig.29)
6. Pull forward the bolt and lock it.
DISASSEMBLY
1. Ensure that the rifle is completely unloaded.
2. Open the bolt, pull it back as far as the bolt stop allows, then with your left
thumb press the bolt stop release which is on the frame left side to take it
off of the frame. (Fig.30)