Manual

7
MAINTENANCE AND CLEANING
The proper maintenance and cleaning of your shotgun will enhance the performance and extend
the service life of your FABARM shotgun.
BARREL : Wet a patch with bore cleaning solvent and wet the inside of the bore by pushing the
wet patch through from the chamber end of the barrel.
BOLT & GAS PISTON : The bolt and the gas piston as important components must be cleaned
thoroughly. A good gun oil and bristle brush should clean it sufficiently.
Avoid over-lubrification. A thin coat of a quality gun oil will help prevent rust.
SHOTGUN REASSEMBLY
1. Put the recoil spring back in place on the magazine tube.
2. Place the bolt assembly on the end of action bar and don’t forget to put the locking bolt in
position first
( FIG.18 ).
3. Guide the assembly into the tracks on both sides of the receiver and snap the cocking
handle into position ( FIG. 19 ).
4. Reinstall the trigger guard assembly and install the two trigger guard retaining pins ( FIG.
20 ).
5. Install the piston with the hollow end forward, install the barrel,after which slide the forend
on the magazine tube and screw on the forend cap ( FIG.21 ).
STOCK DROP MODIFICATION
On FABARM semiauto shotguns, it’s available a set of spacers to modify the drop of the stock +/-
5mm ( 1/5 inch ) from the standard drop. To do it you have to put the spacer around the stock tube
between the receiver and the stock. It’s also possible to modify +/-10 mm ( 2/5 inch ) the drop of
the stock fitting two spacers between receiver and stock.
KINETIC RECOIL REDUCERS
On FABARM semiauto shotguns it’s possible to install the stock and forend kinetic recoil reducer,
each one weight 200 gr.
You can fit the forend reducer instead of the forend ca, and the other in the stock connecting rod
after took out the pad.