Manual

6
LOADING THE SHOTGUN.
1. Before loading the shotgun, put the safety on SAFE by pushing the safety button on the side
where the red stripe is seen.
2. Push the cut-off lever located on the left side of the trigger guard until it clicks
( FIG. 4 ).
3. Pull the cocking handle back until the bolt locks open
( FIG.5 ).
4. Place a shell in the receiver through the ejection port crimped end forward
( FIG.6 ).
5. To chamber the shell, point the shotgun in a safe direction and depress the carrier latch button
located on the left side of the receiver. This will close the bolt chambering the shell in the
process ( FIG. 7 ).
6. Hold the shotgun upside down,cradling the top of the receiver in the palm of your left hand.
Insert the shells by pressing the carrier down with the crimped end of the shell to give access to
the magazine tube until the shell latch snaps into place to hold the shell ( FIG.8 ).
7. Take the shotgun off safe by pushing the safety off.
UNLOADING THE SHOTGUN.
1. To unload the chamber, pull open the bolt and remove the shell.
2. Hold the shotgun upside down.
3. Push the free carrier down ( FIG.9 ) and pull back the multi use button : shells will come out from
the magazine. ( FIG.10 )
REMOVING/INSTALLING CHOKE TUBES
WARNING : Unload the firearm before changing choke tubes. Leave the action open and the
chamber and magazine empty when changing choke tubes.
1. Engage the safety switch.
2. Place the choke tube wrench into the choke tube.
3. Turn the wrench counter-clockwise to remove the choke tube.
4. Select the desired choke tube and insert the tube into the barrel.
5. Screw it in clockwise until tight. Make certain it is tight using the choke wrench but do not over
tighten. A small amount of lubricate on the treads will ensure the choke tube can be installed and
removed with ease.
6. With the action open and the chamber and magazine empty, check the choke tube occasionally
to make sure the tube has not loosened.
NEVER USE THE BARREL WITHOUT ANY CHOKE TUBES.
DISASSEMBLY
1. Place the shotgun on safe and ensure that it is completely unloaded.
2. With the bolt closed,unscrew the forend cap. We suggest to take out first the sling swivels. The
choke wrench can be used to unscrew the magazine cap ( FIG 11a ). Slide off the forend.
Then carefully remove the barrel ( FIG.11b ). The gas piston slides off the front of the magazine
cap shaft ( FIG.12 ).
3. Using the ring of an empty shell,carefully pry the cocking handle out and remove it as show in
FIG.13. Remove the action bar bolt group assembly ( FIG.14 ). Bolt,action bar and recoil spring
being removed from the receiver by being slid down the magazine tube ( FIG.15 ).
4. With a pin punch tap out the two trigger guard pins
( FIG.16 ).
The trigger group can be removed by pulling outward
( FIG.17 ).