Manual

5
SAFETY RULES
WARNING :READ THESE SAFETY RULES & OPERATORS MANUAL BEFORE
HANDLING YOUR FIREARM
• Never point a firearm at anyone and always keep the muzzle pointed in a safe direction.
• Always treat all firearms as if they are loaded. Don’t rely on your gun’s “safety”.
• Firearms should be unloaded when not in use and stored in a safe and secure location. Keep
firearms and ammunition away from children.
• Use correct ammunition. Only use ammunition that exactly matches the caliber or gauge
markings on your firearm.
• Always wear ear and eye protection when shooting.
• Before shooting be sure the barrel is clear of obstructions.
• Never load your firearm until you are in a location where it is safe to shoot. Always keep the
safety engaged until you are ready to shoot.
• Keep your finger off the trigger while loading or unloading the shotgun.
• If your gun fails to fire,keep it pointed in a safe direction,then unload it carefully avoiding
exposure to breech. If your gun fires, but the report of recoil seem weak, unload it and enure
the barrel is not obstructed.
• Don’t alter or modify your gun. Use only genuine parts.
• Clean amd maintain the firearm according to the instructions in this booklet.
• Keep your firearm unloaded. Never carry or store a loaded firearm in a bulding or a vehicle.
ASSEMBLY
FABARM’s semi-automatic shotguns are packed with the barrels separated from the stock-receiver-
forend.
1. Unscrew the forend cap from the stock-receiver-forend group and slide off the forend
( FIG.1 )
2. With the bolt forward,position the barrel extension between the bolt and the inside of the receiver
while ensuring the gas cylinder hanging below the barrel slides over the shaft of the magazine
cap. Move the barrel carefully to the rear until it seats in the receiver and the gas cylinder is
seated in the gas piston (FIG.2 ).
3. Slide the forend over the gas cylinder/piston and magazine tube being careful to guide it all the
way back into the two slots of the receiver then screw the forend cap onto the threaded shaft of
the magazine cap which is protruding from the front of the forend ( FIG.3a ). Tighten this cap
firmly by hand
( FIG 3b ).
Install the sling swivels on the shotgun.