Operation Manual

3
INNER HP CYLINDER For slug or short distance
INNER HP ULTIMATE 12/10 For ultimate distance
The extended choke tubes ( LONG XTENDED + 50 mm and XTREME XTENDED + 100 mm ) are
compatible with the CLASSIS 12 gauge.
Please contact your dealer for more information.
IMPORTANT : STEEL SHOT AMMUNITION “high performance” can be used in your CLASSIS
shotgun with CYLINDER, SHORT 2/10, MEDIUM 5/10, LONG 7/10, XTREME 9/10 choke tubes.
WARNING: Unload the firearm before changing choke tubes.
1. Place the safety in the “on safe” position and open the action. ( Fig.11 )
2. Place the choke tube wrench into the choke tube. ( Fig.12 )
3. Turn the wrench counter-clockwise to remove the choke tube.( Fig.13 )
4. Select the desired choke tube and insert the tube into the barrel.
5. Screw it in clockwise until tight. Make certain it is tight using the choke wrench but do not
over tighten. A small amount of lubricate on the treads will ensure the choke tube can be
installed and removed with ease.
6. Check the choke tube periodically to make sure the tube has not loosened.
DO NOT FIRE THIS SHOTGUN WITHOUT HAVING A CHOKE TUBE INSTALLED.
UNLOADING THE SHOTGUN
1. Put the safety in the SAFE position and point the shotgun in a safe direction. ( Fig.14 )
2. Push the top lever to the right and open the shotgun. ( Fig.15 )
The breech will “break open” and pivot on the hinge pin exposing the chambers.
The extractors will lift the shells out of the chambers where they can be removed by hand.
( Fig.16 )
Remember to keep the breech open until you are ready to reload to prevent any mistakes or
confusion as to the condition of the gun. If the breech is open anyone can see that the gun is
safe.
DISASSEMBLY INSTRUCTIONS
1. After you have made sure that no shotshell remains in the chambers, close the shotgun.
Holding the stock firmly under your right arm, unlock the forend catch with the left hand,
simultaneously carefully separating the forend from the barrels. ( Fig.17 )
2. Open the shotgun and carefully disengage the barrel from the action frame. Carefully
reinstall the forend on the barrel. This will avoid damaging the forend.
3. The top lever can if necessary be release by pushing the cocking lever located in the
bottom of the action frame. ( Fig.18 )
DO NOT STRIP YOUR SHOTGUN ANY FURTHER.
Limit your stripping operations to the removal of the barrel and possibly of the forend. This is quite
enough for normal maintenance. Any further stripping is best performed by a qualified gunsmith.
CARE AND CLEANING
Prior to cleaning the gun, make sure that it is not loaded!
Use and handle your shotgun carefully in order to have many year of trouble free shooting.