Manual

8
9
DISASSEMBLY
1. Place the shotgun on safe and ensure that it is completely unloaded.
2. With the bolt closed,unscrew the forend cap and slide off the forend.
Then carefully remove the barrel (FIG.11). The gas piston slides off
the front of the magazine cap shaft (FIG.12).
3. Using the ring of an empty shell,carefully pry the cocking handle out
and remove it as show in FIG.13. Remove the action bar bolt group
assembly (FIG.14). Bolt,action bar and recoil spring being removed
from the receiver by being slid down the magazine tube (FIG.15).
4. With a pin punch tap out the two trigger guard pins (FIG.16).
The trigger group can be removed by pulling outward (FIG.17).
MAINTENANCE AND CLEANING
The proper maintenance and cleaning of your shotgun will enhance the
performance and extend the service life of your FABARM shotgun.
BARREL : Wet a patch with bore cleaning solvent and wet the inside of the
bore by pushing the wet patch through from the chamber end of the barrel.
BOLT & GAS PISTON : The bolt and the gas piston as important
components must be cleaned throughly. A good gun oil and bristle brush
should clean it sufciently.
Avoid over-lubrication. A thin coat of a quality gun oil will help
prevent rust.
SHOTGUN REASSEMBLY
1. Put the recoil spring back in place on the magazine tube.
2. Place the bolt assembly on the end of action bar and don’t forget to
put the locking bolt in position rst (FIG.18).
3. Guide the assembly into the tracks on both sides of the receiver and
snap the cocking handle into position (FIG. 19).
4. Reinstall the trigger guard assembly and install the two trigger guard
retaining pins (FIG. 20).
5. Install the piston with the hollow end forward, install the barrel,after
which slide the forend on the magazine tube and screw on the
forend cap (FIG.21).