Manual

6
7
LOADING THE SHOTGUN with free carrier feature
1. Before loading the shotgun, put the safety on SAFE by pushing the
safety button on the side where the red stripe is seen.
2. Push the free carrier latch to the rear of the gun until it clicks (FIG. 4).
3. Pull the cocking handle back until the bolt locks open (FIG.5).
4. Place a shell in the receiver through the ejection port crimped end
forward (FIG.6).
5. To chamber the shell, point the shotgun in a safe direction and
depress the carrier latch button located on the left side of the receiver.
This will close the bolt chambering the shell in the process (FIG. 7).
6. Hold the shotgun upside down,cradling the top of the receiver in the
palm of your left hand. Insert the shells by pressing the carrier down
with the crimped end of the shell to give access to the magazine
tube until the shell latch snaps into place to hold the shell (FIG.8).
7. Take the shotgun off safe by pushing the safety off.
UNLOADING THE SHOTGUN with free carrier feature .
1. To unload the chamber, pull open the bolt and remove the shell.
2. Hold the shotgun upside down.
3. Push the free carrier down (FIG.9) and pull back the multi use
button : shells will come out from the magazine. (FIG.10)
REMOVING/INSTALLING CHOKE TUBES
WARNING : Unload the rearm before changing choke tubes. Leave the
action open and the chamber and magazine empty when changing choke
tubes.
1. Engage the safety switch.
2. Place the choke tube wrench into the choke tube.
3. Turn the wrench counter-clockwise to remove the choke tube.
4. Select the desired choke tube and insert the tube into the barrel.
5. Screw it in clockwise until tight. Make certain it is tight using the
choke wrench but do not over tighten. A small amount of lubricate on
the treads will ensure the choke tube can be installed and removed
with ease.
6. With the action open and the chamber and magazine empty, check
the choke tube occasionally to make sure the tube has not loosened.
NEVER USE THE BARREL WITHOUT ANY CHOKE TUBES.