Operation Manual

7
Repeat until the patch comes out clean and free from powder residue. If necessary, pass a bronze
cleaning brush also soaked with oil through the bore. When the barrel is completely clean, dry it
thoroughly and oil by using a clean flannel. This will protect the barrel until the next time you’ll use
the shotgun.
BEARING SURFACE : The bearing surfaces are subject to friction and pressure when opening and
closing the gun and must always be perfectly clean and coated with a light film of oil. Do not apply
too much oil on the action frame so as to avoid making the wood spongy.
EXTERNAL METALLIC SURFACES
Clean the external metallic surfaces of the gun with a lightly oiled cloth and wipe off any trace
of fingerprints. It is also recommended to oil the shotgun lightly each time it is submitted to bad
handling or severe atmospheric conditions.
MECHANISMS
Do not try to reach the firing and ejection mechanism.
WOOD
Apply time to time moderately linseed oil with a non fluffy cloth.
STORAGE
Get into the habit of storing your express rifle out of reach of children.
Your express should be kept in a dry and moderately airy place, away from any strong source of
heat so that the wood will loose any absorbed moisture without distortion or cracking.
ADJUSTABLE TRIGGER
The ASPER express rifle is equipped with an adjustable trigger under 6 positions.
1. Using the appropriate Allen wrench, loosen the lock screw which is on the trigger
(FIG.7)
2. Slide the trigger and put it on your preferred position
( FIG.8 )
3. Using the appropriate Allen wrench, retighten the lock screw.