Fab Glass Frameless Rectangle Mirror Installation Manual FAB GLASS AND MIRROR www.fabglassandmirror.com Call: +1 888-474-2221 Office Timing: 8:30 - 18:00 EST Fax: (614)-334-4919 info@fabglassandmirror.
Thank you for your purchase! It is our desire to make your entire experience from purchase to installation as easy as possible. We ask that you read each step of this installation manual thoroughly to ensure proper installation of your new Mirror. Our installation techniques are very important. Installing your Mirror in any manner other than the steps outlined in this manual may lead to structural failure of your Mirror.
By using your cutting tool, carefully open the package and remove the mirror. 1 Mirror Back Side On the back side of the mirror, use your pencil to mark the center point. 2 Center Point 3 Measure the distance between the center point of the clips and write down the result. 4 Measure the distance between the center point of the clips and write down the result.
5 Hold the mirror against the wall where you want to install it, and mark the wall at the top edge of the mirror with your pencil. 6 Using the results from the Steps 3 and 4, measure down from the top edge mark to the center point between the clips and place another mark, then from that mark measure out to the center of the clip body on each side and mark the wall in both spots. 7 Drill two holes in the wall at the clip body center locations.
Now install the screw in the anchor with your drill. 9 Space from wall Wall (Side View) Leave ¼ “ of space between the wall and the screw head. 10 Distance From Wall 12 Now Fix the clip holes on screws 13 Hang the mirror on the wall by inserting the screw heads into the clips, and press gently against the bottom of the mirror to attach the sticky pads firmly to the wall. Congratulations! You have successfully installed your frameless rectangle mirror.
