Owners manual

Installation Instructions

Dodge Winch Bumper

Product Number: A2950-A2952

Application: 2010+ Dodge Ram HD

Repeat steps 10-14 for the opposite frame rail.

(2013+ DIESEL ONLY) Before re-installing intercooler follow Bumper

Installation Step 1 below.

Your Truck is now ready for the installation of your New FAB FOURS

BUMPER!

IV.

Lights and Wiring Installation

1. Remove headlights following procedure in owner’s manual. On each side, tap

into the three turn indicator wires using supplied tap connectors (reference the

wiring diagram).

2. Connect supplied turn indicator wiring harnesses to factory wires using

supplied tap connectors; See below for wire color guide.

3. Replace headlights in reverse order of removal.

4. Tap into OEM fog light harness using two supplied tap connectors.

5. Connect supplied fog lamp wiring harness to tap connectors following wire

color guide below.

6. Run passenger side fog lamp supply wires across bottom of bumper and tap

into Fab Fours driver side fog lamp wires.

7. Install turn indicators into the plastic light insert using three self- tapping

screws as shown below: