Owners manual

Installation Instructions

Premium Front Sensor Bumper

Product Number: C3050, C3051, C3052

Application: 2015+ CHEVY HD

sensor is pulled out. Do not push on front of sensor as this will

damage the membrane. Place sensors face up in a safe location.

K. Remove plastic housing from OEM bumper by depressing the four plastic tabs

around the inside and pushing housing out. All sensor housings will have to

be placed into the Fab Fours bumper in the same location as they were

removed from OE bumper. (e.g. Outer right sensor clip must go into the outer

right sensor hole in the Fab Fours bumper.)

III. Pre-Installation

NOTE: PLEASE READ THE ENTIRE MANUAL BEFORE

ATEMPTING INSTALLATION!

Ignoring these steps will increase your probability of scratching

the vehicle during product installation.

A. Remove the Bumper from the shipping carton. Lay all items out on a

blanket to prevent damage to the powder coating.

B. For sensor installation run sensor harness under winch tray. Reverse

steps J through M in previous section making sure that the clear

plastic grommet is on properly and sensors appear centered in their