Owners manual

Installation Instructions

Chevy Winch Bumper

Product Number: A2750-A2752

Application: ’11 Chevy 2500-3500 HD

V. Bumper Installation

 Optional: If installing winch and roller fairlead into bumper, do it at this

time. Follow the winch manufacturer’s instructions for installation. If you are

installing a winch with a pulling capacity of 12,000 lbs. or greater, the front

face mounting holes must be used.

If not installing a winch, a license plate may be installed onto the front face of

the bumper using the provided ¼” hardware.

NOTE: IF INSTALLING A WARN 12,000lb+ WINCH, IT IS RECOMMENDED THAT

THE ENGAGE/DISENGAGE HANDLE BE ROTATED FORWARD FOR CLEARANCE

OF THE OEM PIPING

1. Install intermediate mount onto the frame rail using the OEM bumper stud

plates and nuts, and ½” x 1.5 bolts, washers, lock washers and nuts provided

in the hardware kit (labeled 86169-HW). The offset portion of the bracket

should face the outside of the truck. Be sure stud plates are re installed in the

factory direction. DO NOT FULLY TIGHTEN, repeat for other side.

Figure 9 - Intermediate Bracket Installation (Driver Side)

USE OEM

STUD PLATE

USE OEM

STUD PLATE