Owners manual

Installation Instructions

Chevy Winch Bumper

Product Number: A1350-A1352

Application: ’05-Current Chevy

2500-3500 HD

IV. Lights and wiring installation

1. Remove headlights following procedure in owner’s manual. On each side, tap

into the three turn indicator wires using supplied tap connectors.

2. Connect supplied turn indicator wiring harnesses to factory wires using

supplied tap connectors; See below for wire color guide on Fab Fours turn

signal. Use a multi-meter or test light to determine the correct location for

each wire

3. Replace headlights in reverse order of removal.

4. Tap into OEM fog light harness using two supplied tap connectors.

5. Connect supplied fog lamp wiring harness to tap connectors.

6. Run passenger side fog lamp supply wires across bottom of bumper and tap

into Fab Fours driver side fog lamp wires.

7. Install turn indicators into the plastic light insert using three self- tapping

screws as shown below:

Figure 6 – Turn Signal Installation