Tus neeg siv phau ntawv

15
ATTENTION!
Never disassemble the valve completely
when the board is under air pressure: DAN-
GER OF INJURY!
Mount US n ...
Before you start, make sure that the n box
slot is clean and free of sand and dirt!
1. Unscrew the n plate from the screw and
push it into the slot of the n box. Note:
Push the n plate completely forward to-
wards the nose.
2. Insert the small metal slot pins of the n
into the recess and push the n into the
n box towards the tail.
3. The two plastic pins rest then on the n
box.
4. Make sure that the hole of the n is exact-
ly over the thread of the platelet, x the
n with the screw through the hole into
the platelet. Note: For longitudinal ad-
justment loosen the xing screw by a few
turns.
5. Retighten the screw.
Note: The tip of the n points towards the tail
of the SUP.
To disassemble the n, run the assembly
steps in reverse order.
... or mount the SLOT n
Before you start, make sure that the n box
slot is clean and free of sand and dirt!
1. Pull the pen sideways out of the n slot
while pressing on it.
2. Slide the n into the slot so that the re-
cess in the n matches the recess in the
n slot.
3. Push the pin through the small slot until
you hear it click into place.
4. Make sure that the pin is rmly xed to the
n with the cord, otherwise it can be lost.
To disassemble the n, run the assembly
steps in reverse order.
Mounting the seat
(If included in delivery)
1. Fix the upholstered seat and backrest
surface by attaching the two continuous-
ly adjustable straps to the D-rings with
the respective snap hooks.
2. Adjust the straps optimally for you.
Mount paddle
1. Release the locking lever from the exten-
sion bar.
2. Insert the paddle handle into the exten-
sion rod.
3. Pull the paddle handle out of the exten-
sion rod to the desired length. Note: To
adjust the correct length please refer to
the section „Adjusting the paddle length“.
4. Press the locking lever on the extension
bar to clamp the paddle handle.
5. Insert the open end of the extension rod
into the end of the paddle blade. The pin
of the extension rod must audibly engage