Tus neeg siv phau ntawv
16
in the pin bore of the paddle shaft.
To disassemble the paddle, run the assembly
steps in reverse order.
Adjust paddle length
1. Before using the SUP, adjust the paddle
length to your height. There are no global
defaults, which length is the right one for
which body size. We recommend using
the formula to determine the correct
length: body height + 10 - 15 cm.
You can also determine the paddle length as
follows:
1. Extend the non-dominant arm upwards.
2. With the other hand, place the paddle un-
der the extended arm.
3. Lengthen or shorten the paddle until it ts
under the wrist of the outstretched arm.
Important: Do not pull the paddle shaft
out of the paddle handle further than the
„STOP“ mark. Otherwise sufcient stabi-
lity cannot be guaranteed.
USE LEASH
(If included in delivery)
When using the SUP in deep water, attach the
Leash to the ankle.
Never attach the Leash to your ankle when
using the SUP on flowing water (e.g. rapids
and rivers).
Never attach the leash to your ankle in off-
shore winds.
Do not attach the leash to your wrist!
Note: There is no leash on the board as stan-
dard. However, it is recommended to use one
so that the board can be retrieved safely.
https://shop.f2.com
CARRYING THE SUP
Carry the inflated SUP by the handle in the
middle, sideways under the arm.
ATTENTION!
Make sure that the ns point in the direction
of your body so that you do not hurt anyone.
In windy conditions there is a risk that the
SUP will twist, be blown away or cause you
to stumble!
CARRY THE SUP IN YOUR BACKPACK
For transport or storage you can (and should)
put all items in a backpack.
1. Dismantle the SUP as described in the
section „Setup“ in reverse order.
2. Make sure that the SUP is completely
clean and dry.
3. Place the SUP on a clean, level and dry
surface.
4. Roll the SUP towards the valve(!) and se-
cure it with the strap.
5. Carefully stow the SUP
together with all other items in
the backpack.
6. Be careful that the items
and the SUP in the backpack
do not get caught or torn.
CARE
Do not use aggressive clea-
ning agents, brushes with me-
tal or nylon bristles, or sharp
or metallic objects such as
knives or similar. Use only mild
detergent. Clean the SUP only
with the valve closed and after
each use.
1. Remove the ns from the SUP.
2. Place the SUP on a clean, dry and level
surface.
3. Rinse the SUP and ns with fresh fresh
water and a little mild neutral cleaner (or
extra dinghy/SUP cleaner) to remove salt
crystals, grains of sand and other minute