Tus neeg siv phau ntawv

14
• Only insert suitable pump adapters into
the safety valves. Otherwise the valves
could be damaged.
• Do not inflate too hard, otherwise there
is a risk of the weld seams tearing open.
• Do not use a compressor or compres-
sed air bottle to inflate the SUP. This can
cause damage.
• Rinse the SUP with fresh water after use
to prevent damage to the salt crystals.
• Only roll up the SUP when it‘s completely dry.
CONSTRUCTION
Please follow the individual steps of the as-
sembly in the order given.
1. Choose a smooth and clean surface with
enough space to unpack and unfold the
SUP.
2. Make sure that all parts are present and
in perfect condition.
3. Starting with the second setup, inspect
the SUP for any damage, holes or cracks
and seal them as described later. Once
you are on the water, any damage cannot
be repaired.
4. Inflate the SUP. The recommended ope-
rating pressure is 1 bar (15 psi).
5. To inflate the SUP, use commercially avai-
lable foot pumps or double-stroke piston
pumps with appropriate attachments
and pressure gauges.
6. Always inflate the SUP completely.
7. Do not pump up the SUP near sharp or
pointed objects or on rough or pebbly
surfaces.
8. Only open the valve to inflate and deflate.
Otherwise it can become contaminated,
make sure that no sand or similar gets
into the valve.
9. The area around the valve must always be
dry and clean.
10. To reach the maximum pressure, you can
switch from double to single action. Flip
the lever to switch between double action
and single action.
11. Screw the nut thread of the hose onto the
thread of the air pump.
12. Note: Be sure to turn the hose to the
thread marked „IN“.
13. Turn the valve cap counterclockwise out
of the valve.
14. Plug and screw the end of the hose onto
the valve clockwise. Note: The valve pin
must be in the closed position.
15. Use the air pump to pump a maximum of
1 bar (15 psi) into the SUP.
16. Turn the end of the hose counterclockwi-
se out of the valve and place the valve cap
on the valve.
17. Tighten the valve cap clockwise.
Deflate air
1. Turn the valve cover counterclockwise.
1. Remove the valve cover and press down
the valve pin.
1. Note: When you release the valve pin, it
will return to its original position and the
air will not escape any further.
1. Press the valve pin down and turn it
clockwise until it remains in its position.
The air now escapes completely.
1. When the air leak is complete, turn the
valve pin counterclockwise. The valve pin
returns to its original position.