User's Manual

Note:
When the battery is discharged completely, and not used for a while,
the phone will not display the charging icon for about 30 minutes while
charging. After 30 minutes of charging, the phone will display the
charging icon
Power On or Off
1. Hold down the power on/off key for more than one second to switch on.
2. Enter your SIM card PIN, if requested. The phone searches for your network and when detected, will display the idle screen. The external display
shows the signal strength, battery strength and current time and date.
3. When you wish to switch off the phone, hold down the power on/off key for more than two seconds.
Access Codes
There are access codes for your SIM card. These codes help you to protect the phone against unauthorized use.
When requested for any of the code explained below, key-in the appropriate code (displayed as asterisks) and press the OK key.
 PIN
The Personal Identification Number or PIN (4-8digits) protects your SIM card against unauthorized use. The PIN comes with the SIM card; see the
SIM card instruction provided with your card.
If you enter an incorrect PIN three times in succession, the code will be disabled and cannot be used until you re-enable it by entering the PUK.
 PUK
The 8-digit PUK (Personal Unblocking Key) is required to change a disabled PIN. The PUK may be supplied with the SIM card. If not, or in case you
have lost it, please contact your service provider.
To re-enable your PIN, proceed as follows.
1. Key-in the PUK and press the OK key.
2. Enter a new PIN of your choice and press the OK key.
3. When the Confirm New PIN message is displayed, key-in the same code again and press the OK key.
If you enter an incorrect PUK ten times in succession, the SIM card becomes invalid. Please contact your service provider for a new card.
 Pin Password
The 4 ~ 8 digits of password is required when you use the Call barring function. You can obtain the password from your service provider when you
subscribe to this function.
Customize your phone