www.ezvizlife.
What's in the Box Security Light Camera Wire Connector Mounting Screw Quick Start Guide Security Light Camera Lens microSD Card Slot (Behind the Door) Security Light Reset Button PIR Light Arm Screw (Tilt) Camera Arm and Ball-Joint Light Base Ring (Rotation) Camera Base Ring (Rotation) Base Mounting Bracket Base Screw Cap Name Description Light Arm Screw (Tilt) Loosen the arm screw and tilt the arm up to 180º. Tighten the screw when you have the arm in the position you want.
Security Light Camera Installation • Installation height affects motion detection, security light camera recommended installation height: 10 feet (3 m) above the ground. • Camera recommended setting angle: 22 degree as shown below. 22° Step 1 Shut off the electricity at the breaker that controls security light's circuit. • If you don’t know where your breaker is or how to turn off power to your floodlight circuit, consult with a licensed electrician.
Step 4 Install the mounting bracket to the junction box with the mounting screws. 1. Take the existing wires of the junction box through the hole of the mounting bracket. 2. Attach the mounting bracket to your junction box with two mounting screws. Junction Box 3. After installing the mounting bracket to the junction box, the resulting picture is shown as below. Mounting Bracket Mounting Screw Step 5 Connect the wires. Connect the ground wire Connect the power wires 1.
Step7 Restore power at the breaker. Step 6 Place security light camera on the bracket 1. Carefully take all the wires through the hole of the mounting bracket. 2. Align the mounting posts with the holes on security light camera and press together, securing the base screw caps. Mounting Bracket Security Light Camera Turn on power to your security light’s circuit. Base Screw Cap Step 8 Confirm the security light camera has power 1.
--Scan the QR Code on the the security light camera. --Follow the EZVIZ app wizard to finish Wi-Fi configuration. If you want to change your security light camera's Wi-Fi, press and hold the reset button for 5s and repeat this part. • The security light camera works with 2.4GHz Wi-Fi signals. If you have a dual-band router with separate 2.4GHz and 5GHz networks, make sure your phone is connected to the 2.4GHz one.
