Users Manual

3
Setup
Before you use the camera wirelessly, we recommend that you fully charge
the battery. You can use the power adapter to charge the battery.
Step 1: Install the battery
1. Unlock the battery compartment by pressing and holding the latch, at
the same time pull back the battery cover to open the compartment.
2. Pull the battery buckle upwards and insert the battery.
3. Insert a micro SD card into the micro SD card slot if needed (For
detailed operations, you can refer to the camera Quick Start Guide).
4. Close the battery cover.
Write down the verification code located on the battery, you are required
to input it when you live view or play back the video.
Step 2: Charge the Battery (Optional)
1. If the camera is outdoor, bring it indoors to charge the battery.
2. Connect the power cable to the power adapter.
3. Connect the power adapter to an indoor electrical outlet (5V 2A).
Power Outlet
The camera LED indicator status
Slow-ashing red Battery charging
Off Battery fully charged