Users Manual

6
• Before the synchronization, it is suggested to fully charge your camera.
• After the battery is charged, and before the synchronization progress,
please disconnect all the charging cables.
Step 7: Synchronize Base Station with Camera(s)
1. Once your camera is fully charged, bring it close to the base station
(within 2 feet to 3 feet (0.6 to 1 m)).
2. Press and hold the SYNC button on the camera for about 6 seconds
until you hear your camera has been reset successfully.
0.6m-1m
3. Press the SYNC button on the base station. The circular LED indicator
ashes blue when the base station starts to synchronize.
4. Wait for about 150 seconds, and tap to refresh the page.
Camera(s) may take up to 150 seconds to appear in the Add Device
list on the EZVIZ APP.
• The camera LED indicator fast-flashing red indicates the sync
has failed, and you can repeat above steps to try again.
• When the camera LED indicator slowly flashes blue,
synchronization is complete.
• You can sync up to 6 cameras to each base station at the same
time.