Specifications

- 7 -
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
FCC Conditions
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause
undesired operation.
The module is limited to OEM installation ONLY
The OEM integrator is responsible for ensuring that the end-user has no manual instruction to
remove or install module.
When the FCC identification number or ISED certification number is not visible when the
module is installed inside another device, then the outside of the device into which the module is
installed must also display a label referring to the enclosed module. This exterior label can use
wording such as the following: “Contains FCC ID: XXXXX-YYYYYYYYY” and the information
should be also contained in the devices’ user manual.
Copyright description
Without permission, it is forbidden to use or copy all or any part of this manual, which
is especially applicable to trademarks, model naming, part numbers and graphics.
----------------------------------------------------------------------------------------
More information , open.ys7.com
Changes or modifications not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment. The devices must be installed and used in strict
accordance with the manufacturer’s instructions as described in the user documentation that comes
with the product. This device is intended only for OEM integrators under the followingconditions:1) The
antenna must be installed such that 20 cm is maintained between the antenna and user.2) The
transmitter module may not be co-located with any other transmitter or antenna.